How to manually run a data load
- Chichi Lo (Unlicensed)
- Chichi
Every now and then you may need to trigger a manual run for a source or platform job.
This page explains how to use the Batch Manager to perform this function.
This function is restricted to K Administrators
Manually triggering a source run
Select Platform Settings in the side bar
In the pop-out side panel, under Platform Settings click on Sources
next to the Source click the Manual Run icon
After the manual run is triggered, a pop up bar will appear containing a link that can take you to the Monitor tab where you can check the progress of the job.
Troubleshooting failed loads
If the job failed at the extraction step
Check the error. Contact KADA Support if required.
Rerun the source job
If the job failed at the load step, the landing folder failed directory will contain the file with issues.
Find the bad record and fix the file
Rerun the source job
Manually triggering a platform job
Select Platform Settings in the side bar
In the pop-out side panel, under Platform Settings click on Batch Manager
Select the Platform job you want to manually trigger and click Run
A pop-up will appear. Set the manual Click RUN to start the job.
In some cases a As_At DATE may need to be provided
KADA Support will advise when to set this.